Panel repair in Holladay, Utah
$250 to $600 per section is the Holladay price, conditional on availability: half the homes in Holladay were standing by 1966, so plenty of local doors are models no longer in production. Photograph the label first — it is the difference between a section order and a door quote.
- Typical cost in Holladay
- $250–600
- Typical time on site
- 60–120 min
What the Holladay data says
Local dataFreeze–thaw cycles / year
89.4
The main driver of spring fatigue
Expected spring life here
5–7 yrs
Standard 10,000-cycle spring
Median home built
1966
Before the 1993 photo-eye mandate
Elevation
4,429 ft
Drives the freeze–thaw count
Freeze–thaw from NOAA GHCN-Daily normals (Bountiful-Val Verda, 21 km away); median year built from Census ACS; elevation verified against USGS.
The availability question, locally
Doors here are as old as the houses, so start with evidence: the manufacturer label on an end stile or the top section. That photo is what separates ordering a section from being upsold a door. Expect the colour conversation too — sun-aged panels never match new ones, and a full repaint after the swap often beats hunting rare stock.
Colour is the quieter half of the match. A Holladay door facing the weather since 1971 has faded in ways a factory-fresh section has not — and at 4,429 feet the UV does that work faster than at sea level; budget for either an exact-finish order or a whole-door repaint after the swap.
Judge dents by one line — does the crease cross the whole section? If not, it is a cosmetic mark on a working door. If it does, that panel no longer carries its share of the load and should be swapped.
Same metro, different numbers: Holladay in context
Drive fifteen minutes and the inputs change — Millcreek's median build year is 1965; Cottonwood Heights's median build year is 1974; and Murray's median build year is 1971.
Against that backdrop, Holladay holds 89.4 cycles at 4,429 ft with a 1966 median build year — the specific inputs behind every figure above.
The full panel repair guide
This page covers what Holladay changes about the job. For the job itself — steps, parts, quote red flags, the DIY question — the full national guide is the deeper read.
Panel repair: the complete guide →Common questions in Holladay
How much does it cost to replace one garage door panel in Holladay?
Fitted, $250–$600 per section in Holladay. Availability decides everything, so the label inside the door gets photographed before anything gets quoted.
Is a dented garage door panel worth fixing?
If it has not creased the full width and the door still runs square, no — it is a mark, not a fault. Save the $250+ until a full-width crease or binding actually appears.
Get a tech dispatched
Tell us what the door is doing and where you are. We'll connect you with a licensed contractor in your area — usually within the hour.
We pass your details to one licensed contractor serving your ZIP. We don't sell your information to multiple companies. Privacy